SCL Epoxy Sealer #1000

It has the highest viscosity than both Epoxy sealer #300 and #800. It has the ability to fill big hole in Travertine marble. Epoxy #1000 is also used to bond netting to the back side of the marble to strengthen the marble.

TECHNICAL  BULLETIN
Descriptions/Features
Open veins and holes are natural characteristic of a stone. Filling and patching of holes in stone surfaces are part of the fabrication process of the stone. SCL EPOXY SEALER #1000 has an excellent capability to fill those natural big holes from the stone slabs such like the Travertino Stones and ultimately reduce rejection rate of undesirable stones.

SCL Epoxy Sealer #1000 has higher viscosity than SCL Epoxy Sealer #300 & #800.

Benefits:

  • It has an excellent capability to fill big holes.
  • Ideal to use Epoxy Sealer #1000 on backside of the marble to bind the stone netting so as to strengthen those weaken stones to fall apart.
  • It has a harder properties and a faster curing time than Epoxy Sealer #300 & #800.
    Direction to use:

  • The stone has to be dry for at least 24 to 48 hours after grinding.
  • Mix 100grams of Component A to 50grams of Component B will dry within 24 to 36 hours.
  • Once both Component A & Component B are mixed together, stirred them well and immediately apply Epoxy Sealer #1000 onto the marble/granite surface.
  • Use a thin metal/acrylic plate to spread the Epoxy Sealer onto the stone surface in a thin layer.
  • Only mix a small portion at any one time to allow enough time to spread the Epoxy Sealer
    evenly onto the stone surface before the balance Sealer gel-up in the bowl.
  • Between 20 minutes to 30 minutes after 1st coat of application, you are allowed to apply a 2nd coat to ensure all holes are properly filled.
  • Wait for the Epoxy Sealer to dry thoroughly before polishing. The resins will cure and harden after 24 to 36 hours at temperature of 250C (77F). The resins will not cure under 100C to 150C (50F to 59F).

Important notes:

  • Close the cap tight when the product is not use.
  • This product is intended for professional use only.
  • Recommended weight of the floor polishing machine is between 60kg to 80kg and running at 175rpm.

Available packing size:
Small set – Part A: 900gram and Part B: 450gram. Total weight: 1.35kg/set
Medium set – Part A: 3.3kg and Part B: 1.7kg Total weight: 5kg/set

Purchasers are required to test the suitability of the product for their intended use. Mcare Lab Pte Ltd makes no warranty, expressed or implied on the products and the effects. Mcare Lab Pte Ltd shall not responsible for any risks or liabilities, direct, indirect or consequential arising out of the used or the inability to use the product.