SCL Epoxy Sealer #300

It has an excellent penetrating ability to fill fissure hairline cracks and pinholes. Epoxy #300 has the lowest viscosity among #800 and #1000.

TECHNICAL  BULLETIN
Descriptions/Features
SCL Epoxy Sealer #300 is a Two-Components Sealer. It was formulated with Bisphenol A resin added with a reactive diluent to give a lower viscosity to penetrate into crack lines and pin holes which help to reduce rejection rate of undesirable stones. SCL Epoxy Sealer #300 provides good levels of chemical resistance and physical properties, such as aliphatic polyamines and polyamides, usually their curing conditions are at room temperature.

Benefit:

  • SCL-EPOXY SEALER #300 has a lower viscosity than Epoxy Sealer #800 and #1000. It has an excellent penetrating ability and ultimately reduce visibilities of fissure hairline cracks, pin holes, open veins & reduce rejection rate.

Applicable on most types of marble and granite. However, it is not advisable to apply SCL Epoxy Sealers on Limestone and pure white color marble.

    Direction to use:

  • The stone has to be dry for at least 24 to 48 hours after grinding.
  • Mix 100grams of Component A to 50grams of Component B will dry within 24 to 36 hours.
  • Once both Component A & Component B are mixed together, stirred them well and immediately apply Epoxy Sealer #1000 onto the marble/granite surface.
  • Use a thin metal/acrylic plate to spread the Epoxy Sealer onto the stone surface in a thin layer.
  • Only mix a small portion at any one time to allow enough time to spread the Epoxy Sealer evenly onto the stone surface before the balance Sealer gel-up in the bowl.
  • Between 20 minutes to 30 minutes after 1st coat of application, you are allowed to apply a 2nd coat to ensure all holes are properly filled.
  • Wait for the Epoxy Sealer to dry thoroughly before polishing. The resins will cure and harden after 24 to 36 hours at temperature of 250C (77F). The resins will not cure under 100C to 150C (50F to 59F).

Important notes:

  • Close the cap tight when the product is not use.
  • This product is intended for professional use only.
  • Recommended weight of the floor polishing machine is between 60kg to 80kg and running at 175rpm.

Available packing size:
Small set – Part A: 900gram and Part B: 450gram. Total weight: 1.35kg/set
Medium set – Part A: 3.3kg and Part B: 1.7kg Total weight: 5kg/set

Approximate Coverage: 1.35 kg/set covers 40m2 to 50m2

Purchasers are required to test the suitability of the product for their intended use. Mcare Lab Pte Ltd makes no warranty, expressed or implied on the products and the effects. Mcare Lab Pte Ltd shall not responsible for any risks or liabilities, direct, indirect or consequential arising out of the used or the inability to use the product.